Mach64 X Server

["Burke, Jason" <JBurke@lrs.com>]

Aaaarrrrrrrrrrrrrrrrrrgggg!

Ah...That felt better. Hello all, today I am total putting my
brain through the ringer while setting up a new computer
at work to use Linux. Everything on the install went smooth
however, when I try to startup the X server (Mach64 type)
the screen goes blank and locks up. I did manage to get
some info back from SuperProbe, and X -probeonly. If some
one out there can straighten me out, I would really
appreaciate it. Here's my XF86Config file, the SuperProbe
info, my card/monitor type, and the X -probeonly information.

Thanks in advance for any help.....Jason

 <<XF86CONF>> 
 <<SUPERPRO.INF>> 
 <<X.VAL>> 

My card is an ATI Graphics Expression, and my monitor is
a Gateway VX700 with 1600x1200 non-interlaced resoulution,
30-86 KHz horizontal scanning, 50-130 Hz vertical frequency.
This is all the information I have. Thanks again.

XF86CONF

SUPERPRO.INF

X.VAL